Hot tub spa placement form Bathtub installation notes

After the Hot Tub Spa was purchased, the installation was another problem. Before and after the installation and the installation process, there are many places worthy of attention for the owners. The following is a small series of instructions for installation of bathtubs, to understand together under it!

First, the form of placement

There are two types of hot tub spa in general: free-standing and embedded. The free-standing type places the Bathtub directly on the floor of the bathroom or outdoor space. This method is easy to construct, easy to overhaul, and is suitable for use when the floor has been renovated. Embedded is to embed or partially embed the bathtub into the countertop. The embedded bathtub is easier and more convenient for access by the infirm.

Second, bath installation considerations

1, before the installation to determine the various circuit diagrams, and check the outlet and inlet, to figure out the hot and cold water direction of the pipeline, when the installation will save a lot of things.

2. After the bathtub is installed, the bathtub can be filled with water to check if the bathtub is leaking. When there is no problem, open the drain and check the drainage condition.

3. Check whether the bathtub level, front and rear, right and left positions are appropriate, and check whether the drainage facilities are suitable. During the installation process, the bathtub and the water installation shall be protected against dirt, bumps and clogging. The sparks of the angle grinder and spot welder should not be splashed on the bathtub. Otherwise, the glaze will be damaged and the bathtub will be affected.

4, pay attention to bathtub protection. During bath installation and home renovation, the surface of the bathtub can be covered with a soft material, do not stand on the bathtub for construction, or place weight on the edge of the bathtub to prevent damage to the bathtub. Bathtub can be used only af